Skip to main content

Water lift

If one psi is required to lift a column of water 2.3 feet, then in a 3-story building with 10 feet floor-to-floor height, the water pressure needed at the basement of the building to flush a toilet on the third floor, operating at 15 psi is?

Answer30 feet/2.3= 13.04 psi) lift + 15 psi flush = 28 psi required water pressure.

ARE 4.0 exam prep: BS

Comments

  1. Technically if the toilet is on the third floor the rise from the base of the building to the toilet is 2 stories, so 20 feet. If the toilet is 30 high then it would be on the roof.

    ReplyDelete
  2. Good observation - I should clarify the base as basement. Thanks for commenting!

    ReplyDelete

Post a Comment

Try These Too!

Bolted connections

What is the minimum spacing of bolts specified by AISC? and preferred spacing? A. 1 1/4 times the diameter of the bolt; 2 times preferred B. 1 3/4 times the diameter of the bolt; 2 1/4 times preferred C. 2 1/3 times the diameter of the bolt; 2 2/3 times preferred D. 2 2/3 times the diameter of the bolt; 3 times preferred E. 3 times the diameter of the bolt; 3.25 times preferred

Thermal insulation

Which of the following types of thermal insulation can be blown into wall or ceiling cavities with least difficulty, but contains no adhesive properties? I. Cellulose II. Rock wool III. Vermiculite IV. Mineral wool V. Straw VI. Polyicynene Answer I, II and III are loose-fill types of insulation that can be blown. IV comes in batts, V can come in boards or bales, VI is a spray-foam that adheres to the cavity. ARE 4.0 exam prep: BS

Imageability

Select 5 components that contribute to imageability , Lynch's concept that posits that a highly imageable city is readily understandable and distinct. A. districts B. social structure C. edge D. landmark E. nodes F. overlapping systems G. paths H. legibility Answer A, C, D, E, G are components that contribute to defining imageability. ARE 4.0 exam prep: PPP