Skip to main content

Environmental impacts

Four steps in a process of evaluating a material or product to be used in a building:
1. Establish the intent and scope of the study 2. Conduct an inventory analysis 3. Carry out an impact assessment 4. Run an improvement analysis and summarize the study results
This describes:
A. Life-cycle cost analysis
B. Environmental impact statement
C. Life-cycle assessment
D. IEQ survey

AnswerC. Life-cycle assessment or LCA

ARE 4.0 exam prep: SPD

Comments

Post a Comment

Try These Too!

Bolted connections

What is the minimum spacing of bolts specified by AISC? and preferred spacing? A. 1 1/4 times the diameter of the bolt; 2 times preferred B. 1 3/4 times the diameter of the bolt; 2 1/4 times preferred C. 2 1/3 times the diameter of the bolt; 2 2/3 times preferred D. 2 2/3 times the diameter of the bolt; 3 times preferred E. 3 times the diameter of the bolt; 3.25 times preferred
Post a Comment
See the answer »

Brick bonds

What distinguishes the English Bond pattern from the Dutch Bond pattern in this image? Answer In the English Bond, stretchers are aligned; In the Dutch (cross), stretchers move by a half each course (not aligned). ARE 4.0 exam prep: BDCS
Post a Comment
See the answer »

Collector walks

Walks next to parking areas where vehicles are able to overhang the walk should be a minimum width. What is this minimum in feet? A. 3 feet B. 4 feet C. 5 feet D. 6 feet Answer These walks should be 6 ft (D.) minimum in width. ARE 4.0 exam prep: SPD
Post a Comment
See the answer »