Skip to main content

Electrical circuits

A circuit that feeds a motor must be oversized so that the rated load of the motor is not more than 80% of the capacity of the circuit. NEC requires that for single motor installation, the current used in the wire size calculation must be _____ times the load current from the applicable single-phase or 3-phase tables.
Answer1.25 times (1 / 0.80)

ARE 4.0 exam prep: BS

Comments

Post a Comment

Try These Too!

Space programming

What are two common ways to identify and document physical and functional relationships amongst spaces in the programing phase? Choose 2 A. adjacency diagram B. adjacency matrix C. bubble diagramming D. block-stack diagram Answer A & B The adjacency diagram and adjacency matrix are used in programming stage, while C & D are employed as the initial design effort begins as more physical representations of plan are introduced. ARE 4.0 exam prep: PPP
Post a Comment
See the answer »

Overimprovement

While underimprovement describes property that is not being put to its highest and best use (reducing its value), when does overimprovement apply?
Post a Comment
See the answer »

Vapor retarders

In this section, a ceiling assembly separates the attic space above from the room interior below. If the building is located in Lewisville, Texas (hot-humid zone), where is the predicted location of condensation and what is the predicted condition of the gypsum board in this assembly? (Select 2 from the following) A. outside face of vapor retarder B. inside face of vapor retarder C. gypsum board will be wet D. gypsum board will be dry
2 comments
See the answer »