Skip to main content

Lighting selection

In a materials reference showroom, an area of study carrels is set aside for industry professionals to review product literature and reference materials. The showroom's reference center is open from 7 am through 10 pm every day and the owners of the center would like to reduce the energy consumption and expense. Which of the following is the best choice of lighting selection for this portion of the center.
A. ambient lighting
B. general illumination
C. task lighting
D. accent lighting



Answer is C. task lighting would permit energy conservation as light at unused carrels can be turned off or lowered.

are-review PPD-PDD resources

Comments

Post a Comment

Try These Too!

Imageability

Select 5 components that contribute to imageability , Lynch's concept that posits that a highly imageable city is readily understandable and distinct. A. districts B. social structure C. edge D. landmark E. nodes F. overlapping systems G. paths H. legibility Answer A, C, D, E, G are components that contribute to defining imageability. ARE 4.0 exam prep: PPP
Post a Comment
See the answer »

Interior Glazing

Safety glazing (tempered glass, laminated glass or impact resistant plastic) is not required at this interior window (18sf glazed area). Which of these satisfies conditions for using non-safety glazing? A. Within 36 inches horizontally of a walking surface B. Bottom edge is less than 60" above the plane of the adjacent walking surface C. 1 1/2 in protective bar between 34 and 38 inches on accessible side D. Exposed area of the pane is greater than 9 sf Answer C. 1 1/2 inch protective bar between 34-38 inches on accessible side. In this case, safety glazing is not required. ARE 4.0 exam prep: BDCS
Post a Comment
See the answer »

Bolted connections

What is the minimum spacing of bolts specified by AISC? and preferred spacing? A. 1 1/4 times the diameter of the bolt; 2 times preferred B. 1 3/4 times the diameter of the bolt; 2 1/4 times preferred C. 2 1/3 times the diameter of the bolt; 2 2/3 times preferred D. 2 2/3 times the diameter of the bolt; 3 times preferred E. 3 times the diameter of the bolt; 3.25 times preferred
Post a Comment
See the answer »