Skip to main content

Wind movement on surfaces


Wind exerts pressure (i.e. positive, negative) on different building surface conditions. This diagram shows positive pressure on the windward vertical and normal to windward roof surfaces. Which condition is indicated?

A. roof slope up to 7:12
B. roof slope greater than 7:12
C. flat roof

AnswerB. roof slope greater than 7:12 (negative pressure or suction is exerted on the leeward side of both < and > 7:12 slopes).
ARE 4.0 exam prep: SPD

Comments

Post a Comment

Try These Too!

Moisture content in wood

The amount of shrinkage, weight, strength, and withdrawal resistance of nails is affected by the moisture content in wood. Wood that is grademarked kiln dry has a maximum moisture content of: A. 15% B. 19% C. 25% D. 30% Answer A. 15%. Dry lumber moisture content cannot exceed 19%. ARE 4.0 exam prep: SS
Post a Comment
See the answer »

Cantilevered beam

The bending moment in a cantilevered beam is negative. Which of the following statements are true? A. the top fibers are in compression B. the bottom fibers are in compression C. rebar placement should be either at the top or the bottom D. gravity loads are not a factor for negative moment Answer B. the bottom fibers are in compression in a cantilevered beam, so top fibers are in tension which requires rebar placement at the top to resist tension. ARE 4.0 exam prep: SS
Post a Comment
See the answer »

Wood stairs

In wood stair construction, what is the difference between a carriage and a stringer?! Answer A carriage is the principle support for the treads and risers, whereas the stringer is the finish member (face) that treads and risers terminate against. ARE 4.0 exam prep: BDCS
Post a Comment
See the answer »