Skip to main content

Planning diagrams



When would the following diagram be used?
A. to illustrate the initial results of spatial organization using an adjacency diagram as a basis
B. to illustrate the required adjacencies and priorities of relationships just prior to initial space planning
C. to represent relationships in a matrix of adjacencies
D. to indicate scheduling process

AnswerA. the block diagram illustrates the initial results of spatial organization using an adjacency diagram as a basis.

ARE 4.0 exam prep: PPP

Comments

Post a Comment

Try These Too!

Bolted connections

What is the minimum spacing of bolts specified by AISC? and preferred spacing? A. 1 1/4 times the diameter of the bolt; 2 times preferred B. 1 3/4 times the diameter of the bolt; 2 1/4 times preferred C. 2 1/3 times the diameter of the bolt; 2 2/3 times preferred D. 2 2/3 times the diameter of the bolt; 3 times preferred E. 3 times the diameter of the bolt; 3.25 times preferred
Post a Comment
See the answer »

Curb cuts

In a curb ramp that has either built-up or flared sides, the maximum slope of the incline should not exceed 1:12. What is the maximum slope of the (flared)sides in these types of curb ramps? A. 1:8, B. 1:10, C. 1:12, D. 1:16
Post a Comment
See the answer »

Soil Analysis

In sieve analysis, one of the first results measured is the % retained in each sieve of the total sample (W sieve / W total x 100%). If the illustrated sample indicates equal amounts of various sizes of aggregate, where most of the voids in such material will be filled with particles, which gradation term is used? A. Narrow gradation B. Gap gradation C. Dense gradation D. Open gradation E. Rich gradation
Post a Comment
See the answer »