Skip to main content

Environmentally responsible design

B101-2007 incorporates a public policy of the AIA that architects must be environmentally responsible in performing their services. As part of the architect's basic services, an architect is required to discuss during schematic design phase the feasibility of including environmentally responsible design approaches in the project. In reviewing environmentally responsible design alternatives, the client agrees that energy modeling should be performed. How is this type of service classified?

AnswerThis should be identified in Article 4 as an additional service (extensive environmentally responsible design) for which additional compensation is required.

ARE 4.0 exam prep: CDS

Comments

Post a Comment

Try These Too!

Building Efficiency

Convert the usable area of classrooms planned with medium efficiency level of new construction to the gross building area given the following model factors: Net Assignable Square Feet: 10,000, Space Factor: 1.5, Building Efficiency Ratio: 67%
6 comments
See the answer »

Construction type

Fire-resistance rating requirements listed in IBC Table 601 list major building elements based on construction classification. Match these two criteria correctly, choose 2 A. Type IB = roof construction 1 1/2 hrs B. Type IIB = exterior bearing walls 1 hr C. Type IIIA = structural frame 1 hr D. Type VB = floor construction 1 hr E. Type IVHT = exterior bearing walls 2 hr Answer C. and E. are correct. HT = heavy timber. ARE 4.0 exam prep: BDCS Reference tip:  Find the online version of Table 601 in this discussion paper here
2 comments
See the answer »

Vapor retarders

In this section, a ceiling assembly separates the attic space above from the room interior below. If the building is located in Lewisville, Texas (hot-humid zone), where is the predicted location of condensation and what is the predicted condition of the gypsum board in this assembly? (Select 2 from the following) A. outside face of vapor retarder B. inside face of vapor retarder C. gypsum board will be wet D. gypsum board will be dry
2 comments
See the answer »