Skip to main content

Mold prevention

What is the only way to prevent and control mold in buildings?
A. lower the average indoor temperature
B. remove the nutrient source that allows mold to flourish
C. control moisture conditions
AnswerC. Since mold grows in a temp. range of 40-100degF and all building components are potential nutrients, moisture control in areas that can sustain mold must be addressed.

ARE 4.0 exam prep: BS

Comments

Post a Comment

Try These Too!

Building Efficiency

Convert the usable area of classrooms planned with medium efficiency level of new construction to the gross building area given the following model factors: Net Assignable Square Feet: 10,000, Space Factor: 1.5, Building Efficiency Ratio: 67%
6 comments
See the answer »

Vapor retarders

In this section, a ceiling assembly separates the attic space above from the room interior below. If the building is located in Lewisville, Texas (hot-humid zone), where is the predicted location of condensation and what is the predicted condition of the gypsum board in this assembly? (Select 2 from the following) A. outside face of vapor retarder B. inside face of vapor retarder C. gypsum board will be wet D. gypsum board will be dry
2 comments
See the answer »