Skip to main content

Shop drawing review




Shop drawing review stamps will typically state that the review does not include which of these:
I. confirming and correlating all quantities
II. selecting fabrication processes
III. coordinating the work with that of other trades
IV. general conformance with design concept
V. markings as noted

AnswerI, II, III are typical exclusions of a shop drawing review. IV is the purpose of the review and V is a response given in the review.

ARE 4.0 exam prep: CDS

Comments

Post a Comment

Try These Too!

Moisture content in wood

The amount of shrinkage, weight, strength, and withdrawal resistance of nails is affected by the moisture content in wood. Wood that is grademarked kiln dry has a maximum moisture content of: A. 15% B. 19% C. 25% D. 30% Answer A. 15%. Dry lumber moisture content cannot exceed 19%. ARE 4.0 exam prep: SS
Post a Comment
See the answer »

Cantilevered beam

The bending moment in a cantilevered beam is negative. Which of the following statements are true? A. the top fibers are in compression B. the bottom fibers are in compression C. rebar placement should be either at the top or the bottom D. gravity loads are not a factor for negative moment Answer B. the bottom fibers are in compression in a cantilevered beam, so top fibers are in tension which requires rebar placement at the top to resist tension. ARE 4.0 exam prep: SS
Post a Comment
See the answer »

Wood stairs

In wood stair construction, what is the difference between a carriage and a stringer?! Answer A carriage is the principle support for the treads and risers, whereas the stringer is the finish member (face) that treads and risers terminate against. ARE 4.0 exam prep: BDCS
Post a Comment
See the answer »