Skip to main content

Standing seam roof

Metal roof panels (interlocking metal sheets with a minimum weather exposure of 3 square feet) may have different minimum allowable slopes depending on whether they are lapped, nonsoldered with or without lap sealant applied. With applied lap sealant, what is the minimum units vertical : units horizontal?
A. 1/4 vertical in 12 units horizontal (2%)
B. 1/2 vertical in 12 units horizontal (4%)
C. 2 vertical in 12 units horizontal (17%)
D. 3 vertical in 12 units horizontal (25%)

AnswerB. 1/2:12 or 4% slope. Without lap sealant, it's 3:12

ARE 4.0 exam prep: BDCS

Resource tip: IBC Roof assemblies, metal roof panels - see 1502-1507

Comments

Post a Comment

Try These Too!

Townships double post!

How many sections are contained within a township? Answer 36 (each is 1 mile square) What are the dimensions of 1/2 of a township? H & W Answer 18 miles square (3x6 sections) ARE 4.0 exam prep: SPD
4 comments
See the answer »

Cantilevered beam

The bending moment in a cantilevered beam is negative. Which of the following statements are true? A. the top fibers are in compression B. the bottom fibers are in compression C. rebar placement should be either at the top or the bottom D. gravity loads are not a factor for negative moment Answer B. the bottom fibers are in compression in a cantilevered beam, so top fibers are in tension which requires rebar placement at the top to resist tension. ARE 4.0 exam prep: SS
Post a Comment
See the answer »

Parking units

What are the car stall dimensions for a compact car? Answer A compact car stall size can be set by each municipality and therefore varies. Generally it is 7ft 6in wide by 15ft 0in long. However, in Fresno CA it's 8 1/2ft x 16ft and according to an Iowa urban design manual, it's 7ft 6in by 16ft. ARE 4.0 exam prep: SPD
4 comments
See the answer »