Skip to main content

Piping symbols

Identify from top to bottom:
1.
2.
3.
4.
5.


Answer: 1.pipe elbow down, 2.pipe elbow up, 3.pipe tee down, 4.pipe tee up.

are-review PPD & PDD Exam resources

Comments

Post a Comment

Try These Too!

Efficient columns

The radius of gyration in the Y-Y axis would be equal to that in the X-X axis in an ideally efficient column. Which of the following sections are most appropriate for both heavy loads and for which many beam connections will be necessary? A. pipe column B. square tube column C. wide-flange column D. C-shape channel E. WT shapes Answer C. wide-flange column. Pipe & square tube columns are more ideal shapes, but are appropriate for light to moderate loads. The radius of gyration of wide-flange shapes can be nearly or close to equal. ARE 4.0 exam prep: SS
Post a Comment
See the answer »

Elevator bank layouts

An office building has an elevator bank with 4 elevators where 2 cabs side-by-side are arranged opposite the other 2. Each of the elevators is 3500-pound capacity with an interior cab dimension of 6'8" x 5'4". What is the recommended corridor width at this group? A. 8 feet B. 9 feet C. 11 feet D. 12 feet Answer C. 11 feet. At 1.5-2 times the car depth (5'4), this could be a range, but 10 feet is a minimum for groups of 4 or more. Therefore C is the best choice. ARE 4.0 exam prep: BDCS
1 comment
See the answer »

Bolted connections

What is the minimum spacing of bolts specified by AISC? and preferred spacing? A. 1 1/4 times the diameter of the bolt; 2 times preferred B. 1 3/4 times the diameter of the bolt; 2 1/4 times preferred C. 2 1/3 times the diameter of the bolt; 2 2/3 times preferred D. 2 2/3 times the diameter of the bolt; 3 times preferred E. 3 times the diameter of the bolt; 3.25 times preferred
Post a Comment
See the answer »