Skip to main content

Construction products

Which document identifies toxicity and proper spill or leak procedures for a substance during construction?
A. Supplementary conditions
B. Product specifications, Section II Products
C. Material Safety Data Sheet
D. Instructions to bidders

AnswerC. MSDS = Material Safety Data Sheet. Usually a required submittal as product data, which contractor must have available at jobsite to comply with OSHA.

ARE 4.0 exam prep: CDS

Comments

Post a Comment

Try These Too!

Bolted connections

What is the minimum spacing of bolts specified by AISC? and preferred spacing? A. 1 1/4 times the diameter of the bolt; 2 times preferred B. 1 3/4 times the diameter of the bolt; 2 1/4 times preferred C. 2 1/3 times the diameter of the bolt; 2 2/3 times preferred D. 2 2/3 times the diameter of the bolt; 3 times preferred E. 3 times the diameter of the bolt; 3.25 times preferred
Post a Comment
See the answer »

Curb cuts

In a curb ramp that has either built-up or flared sides, the maximum slope of the incline should not exceed 1:12. What is the maximum slope of the (flared)sides in these types of curb ramps? A. 1:8, B. 1:10, C. 1:12, D. 1:16
Post a Comment
See the answer »

Soil Analysis

In sieve analysis, one of the first results measured is the % retained in each sieve of the total sample (W sieve / W total x 100%). If the illustrated sample indicates equal amounts of various sizes of aggregate, where most of the voids in such material will be filled with particles, which gradation term is used? A. Narrow gradation B. Gap gradation C. Dense gradation D. Open gradation E. Rich gradation
Post a Comment
See the answer »